This is an RC-scale aluminum rear suspension mount set designed specifically for the Tamiya TA07 chassis. The machined aluminum pieces replace the stock plastic mounts to provide a stiffer mounting point for rear suspension linkages and a consistent baseline for geometry adjustments.
Installation uses the original TA07 rear pickup and mounting points; standard hex drivers and basic workshop checks are all that is required. Remove the factory mount, clean mating surfaces, fit the aluminium mount in the correct orientation, and secure using the original fasteners while checking thread engagement.
As a chassis-level hop-up, this mount set increases mounting stiffness and repeatability rather than directly altering spring or damper valving. Expect crisper rear response and a steadier roll center; make suspension changes incrementally and verify handling on the track or at the field.
Copyright © 2008-2026 rcjaz.ca All rights reserved
