Tamiya 51129 TG10-Mk.2 10mm Adjuster Nut Set 4pc SP-1129  [51129]

Tamiya 51129 - TG10-Mk.2 10mm Adjuster Nut (4 pcs.) SP-1129
Price:
CAD$7.60
Brand:
Tamiya
Model:
51129
Condition:
Brand New
Write a review

Fine Tuning for TG10-Mk.2 with Tamiya 51129

The Tamiya 51129 10mm Adjuster Nuts are a compact upgrade for tuners working on TG10-Mk.2 chassis. Supplied as a set of four, these adjusters let you make small changes to suspension geometry and wheel alignment without swapping major parts.

Fitment and Practical Use

Designed for the TG10-Mk.2 line, these nuts match the dimensions used on the original mounting points to ensure a tidy fit. Their 10mm sizing allows for consistent, repeatable adjustments that help when dialing in handling for different track surfaces.

Simple Installation Advice

Fitting is straightforward: remove the existing nuts and replace them with the Tamiya 51129 adjusters to gain more granular tuning control. Check tightness and recheck alignment after a few runs to confirm settings.

Will these nuts work with older TG10 variants?

They are made for TG10-Mk.2 geometry but may fit earlier TG10 versions if the thread and spacing match. Verify measurements before fitting.

Do I need special tools to install them?

Standard nut drivers or a socket set sized for 10mm will do. Use a torque approach appropriate for small RC hardware to avoid over tightening.

How often should I check these during racing?

Inspect them before each meeting and again after a couple of runs. Small shifts in setup are common, so frequent checks keep handling consistent.

Copyright © 2008-2026 rcjaz.ca All rights reserved