Tamiya 22106 for 2WD Buggy One-Piece Steel Front Axle & Hub  [22106]

Integrated steel axle and hub for 2WD buggies

This RC-scale spare merges the front axle and hub into a single steel component designed for 2WD buggy front wheel assemblies. Combining both parts reduces the number of pieces and provides a repeatable mounting interface for the wheel and hub while serving as a direct-replacement style accessory for compatible front setups.

Design and role: the one-piece layout focuses on easier service and consistent alignment, helping to speed wheel removal and reassembly during pit-side work or scheduled maintenance. As an aftermarket steel component it increases front-end mass and alters the front response, so it is relevant when tuning steering feel and unsprung mass for overall handling balance.

Installation notes: fitting requires that the front assembly accept the combined axle/hub geometry, so confirm axle mounting points and hub bore on your buggy before installing. When replacing the stock parts, inspect bearings and retaining hardware for wear, ensure correct axle seating and hub engagement, and tighten fasteners to manufacturer torque specs to prevent play in the front end.

A practical choice for 2WD buggy crews seeking a simplified front axle/hub layout and faster wheel service without changing hub mounting standards.