Tamiya 15550 Jr HG Carbon Brake Stay (1.5mm) - Mini 4WD Replacement Brake Plate  [15550]

Replacement carbon brake stay for 1/32 Mini 4WD

The Tamiya 15550 Jr HG Carbon Brake Stay (1.5mm) is supplied as a carbon spare plate for use as a front, rear or side brake stay on 1/32 Mini 4WD cars and is listed as an accessory in the Mini 4WD range.

This item is a 1.5mm nominal thickness carbon plate, laser cut for brake stay applications. It arrives as an unfinished carbon stay for hobbyists who swap or stock spare mounting plates; mounting screws and conversion parts are not included.

Material and form: the part is a flat carbon plate approximately 1.5mm thick. It is intended for setups that use standard stay hole patterns; measure hole centres and screw diameters on your existing stay before fitting.

Fit guidance and installation tips

• Made for 1/32 Mini 4WD brake stay use, suitable as a front, rear or side stay plate.
• Check that hole spacing lines up with your car's stay mounts; minor re-drilling may be necessary on some builds.
• Select screws and washers that match your mounts and avoid overtightening to prevent carbon edge damage.
• Sold only as the carbon stay plate; it is not a body or chassis replacement kit.
• Not intended for Wild Mini 4WD or Scale Mini 4WD upgrade parts.