Tail Link Root End for Eagle/Freya/EX/SX - HI0404553 by Hirobo  [HI0404553]

HIROBO 0404-553 ROOT END #0404553
Price:
CAD$8.67
Brand:
Hirobo
Model:
HI0404553
GTIN:
4512895108274
Condition:
Brand New
Write a review

Function and fitment

This Hirobo root end, listed as HI0404553, is supplied as a service replacement part for Eagle, Freya, EX and SX helicopter lines. It functions as the terminal link in tail linkage assemblies where a compact, serviceable joint is needed for routine maintenance and part renewal.

Fitment details note that this item is used across Eagle/Freya/EX/SX models; always confirm the part number on your airframe before ordering. The product is sold as a single replacement component intended to restore correct linkage geometry when an original root end shows wear or excessive play.

Installation and setup tips: remove the worn root end from the tail linkage, inspect adjacent pushrods and bearings for wear, install the new root end in the correct orientation ensuring free movement, then check tail pitch and yaw response at low throttle. Carry out minor trim adjustments if required to re-establish neutral linkage alignment before full-power flights.

Is the HI0404553 root end listed for Eagle and Freya models?

The part is listed for use on Eagle, Freya, EX and SX helicopter families; always verify compatibility against your airframe parts list before purchase to ensure fitment.

What is the correct procedure to fit this replacement?

Remove the worn root end, inspect surrounding linkage components and bearings for damage, fit the new root end in the correct orientation, secure any fasteners, and confirm smooth, unrestricted movement prior to flight.

Which post-install checks should I run?

Check for end-to-end play in the linkage, verify tail control centring, perform low-power control checks, and re-trim if necessary to ensure predictable handling before returning to normal operation.

Copyright © 2008-2026 rcjaz.ca All rights reserved