Tail Housing Replacement for Lepton LEX - HI0304046 by Hirobo  [HI0304046]

Lepton LEX Tail Case Replacement

This tail housing is a replacement component identified by the Hirobo HI0304046 model number and intended for use with the Lepton LEX tail assembly. It is supplied as a service part to restore the tail case where wear or minor damage has affected fitment or alignment.

Fit this housing during routine inspections or if you notice looseness around the tail shaft. The housing forms the mounting interface for the tail drive and bearings in the Lepton LEX tail section and helps maintain correct alignment for dependable tail control responsiveness.

Installation notes: remove the tail boom and tail-case fasteners to access the housing, transfer any bearings or internal components to the replacement housing as required, and reassemble while checking tail shaft runout and control linkage free-play. Final setup should focus on tail trim and rotor balance rather than altering the housing itself.