TA05 / TT-01 Compatible Ferrari FXX Pre-Painted Polycarbonate Body Tamiya 51260  [51260]

Tamiya 51260 - Ferrari FXX Lightweight Body Finish SP-1260
Price:
CAD$66.21
Brand:
Tamiya
Model:
51260
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Pre-painted Ferrari FXX 1/10 body

This is a ready-to-fit, pre-painted 1/10-scale Ferrari FXX body produced by Tamiya, supplied as a lightweight polycarbonate shell with factory-applied markings. It is intended as a spare or replacement body for scale on-road RC models and is delivered with the paint and decals already applied so hobbyists can focus on fit and setup rather than finishing work.

The shell is formed for scale proportions and designed for trimming to common 1/10 on-road chassis. Note that short wheelbase and wide tread variants require additional checks before fitment because their mounting points and wheel clearance differ from the standard layouts listed below.

Specifications

  • Item Tamiya 51260 - Ferrari FXX Lightweight Body Finish SP-1260
  • Material Lightweight polycarbonate
  • Model Number 51260
  • Compatibility 1/10 on-road chassis fitting standard wheelbase and tread layouts

Compatibility

  • TA05
  • TA04
  • TT-01
  • TGS
  • TNS
  • TB-02
  • TB-01
  • TL-01
  • TB Evolution IV
  • TRF415
  • TG10-Mk.1

Excluding short wheelbase and wide tread chassis, confirm body post alignment and wheel clearance before final mounting.

As a finished spare body, this item reduces prep time for scale on-road projects and provides a lightweight, pre-decorated option for replacement or visual upgrades; verify compatibility and trim carefully for non-standard chassis variants.

How do I fit this body to a TA05 chassis?

Start by test-fitting the shell to check body post alignment and wheel clearance. Trim mounting holes and wheel arches as required, then secure using the chassis posts and silicone grommets suitable for 1/10 bodies.

Do I need to remove the decals before trimming?

No, the factory-applied markings are placed to accommodate typical trimming. Protect visible decals while cutting and perform test trims to avoid accidental removal of applied graphics.

What is the best method to cut wheel arches?

Use a sharp body reamer or fine scissors and work slowly, trimming small amounts and checking against tyre clearance frequently to achieve a clean edge and correct fit.

Will this mount without modification on TT-01?

TT-01 standard layouts are listed as compatible, but confirm that body post spacing and wheel offset match your specific chassis before final fitting; minor trimming may still be required.

Can I add extra mounting points for a tighter fit?

Yes, you can add additional mounting tabs or use double-sided tape on secure areas; ensure any added fixings do not interfere with steering or suspension movement.

Copyright © 2008-2026 rcjaz.ca All rights reserved