SVi 300mm i-Connector Servo-to-Receiver Cable - Futaba FUEBB0155  [FUEBB0155]

300mm i-Connector Servo Lead

This Futaba FUEBB0155 300mm i-Connector cord is an RC-scale accessory designed to link SVi-compatible servo outputs to the receiver, keeping wiring neat inside radio trays and confined servo compartments. The 30-strand conductor is chosen to maximise flexibility for tight routing paths without adding bulk.

Compatibility centres on SVi signal wiring between an SVi-capable servo or device and the receiver input; confirm your receiver accepts SVi wiring conventions before installation. The cord length and multi-strand construction help reduce strain on connector joints and make for cleaner cable management.

Installation tips: run the cable alongside existing harnesses, avoid acute bends at connector ends, and secure gently with tape or small cable ties to stop chafing on chassis edges. For digital servos with high update rates, ensure connectors are fully seated and inspect routing for any potential noise sources.

Role in setup: this cord is a wiring component rather than a tuning part; correct routing and secure connections support consistent servo response during radio and servo calibration.