Super X chassis Carbon Rear Roll Stay 1.5mm - Tamiya 95716 Jr HG  [95716]

Replacement Tamiya 95716 Jr HG carbon rear roll stay for Super X chassis

The Tamiya 95716 Jr HG Carbon Rear Roll Stay is a 1.5mm carbon fiber rear roll stay supplied as a replacement or service spare for Mini 4WD cars that use the Super X chassis. It is listed as a spare part and matches the Super X mounting pattern.

Made from a thin 1.5mm carbon sheet, this rear roll stay gives a stiff mounting plane for rear rollers while keeping overall profile low. The component suits builders who want a direct-fit carbon stay for Jr HG sized hardware on Super X projects, with emphasis on material and fit rather than cosmetic finish.

Fitting requires the standard Super X chassis rear stay screws and associated spacers; tighten fasteners carefully to avoid crushing the carbon laminate. Experienced model builders will recognise that a 1.5mm plate balances rigidity with a little flex; use shims and washers as needed to protect the screw holes and control plate contact.

When fitting a replacement, check mounting holes for any initial delamination and verify roller alignment with the rear bumper and plates. Lightly sand carbon edges to remove splinters if necessary, and do not modify hole locations unless you plan to ream and reinforce the area for different screw sizes.

A practical carbon rear roll stay for Super X chassis use; ideal as a direct spare or to replace worn plastic parts while keeping the original Super X mounting layout.