TRAXXAS MAXX Stainless Steel 38pcs Chassis Protection TXMWZSP1B by GPM  [TXMWZSP1B]

Precision stainless chassis guards for TRAXXAS MAXX

This 38pcs stainless steel protection kit is made for the 1/10 4WD TRAXXAS MAXX W/WIDE MAXX chassis and gives layered coverage for the front, centre and rear underside of the truck. Parts are laser-cut from stainless steel, hand-polished for a clean finish and use a mix of solid and hollow plates to reduce abrasion and deflect direct rock strikes from the frame.

The components install under the stock chassis without cutting, using the supplied gold screws and Delrin spacers to attach at factory mounting points. The kit is intended to reinforce the chassis and improve impact resistance during club racing and trail running, not for use on full-size vehicles.

Supplier notes on construction: the front and rear bumper plates are produced thicker than the side and centre pieces to protect primary impact zones, each face is polished for corrosion resistance, and every part is inspected for edge quality and fit before packing.

Fit this stainless steel plate set to strengthen the MAXX chassis and reduce wear for more consistent lap times; install using the supplied fasteners and spacers to keep the original chassis layout intact.