SSR-VI Stabilizer Control Arm for precise linkage - HI0414217 by Hirobo  [HI0414217]

HIROBO 0414-217 SSR-VI STABILZER CONTROL ARM #0414217
Price:
CAD$29.19
Brand:
Hirobo
Model:
HI0414217
GTIN:
4512895129231
Condition:
Brand New
Write a review

Part role and overview

A replacement control arm from Hirobo designed for the SSR-VI stabilizer assembly on RC helicopters. It is intended to correct linkage geometry and help recover accurate tail-centre behavior, without making claims about material composition. Fit this arm when replacing worn linkage points or when fine tuning stabilizer movement during setup.

Specifications

  • Item: Stabilizer Control Arm
  • Material: Not specified
  • Model Number: HI0414217
  • Compatibility: SSR-VI

Fit this control arm to restore or adjust SSR-VI stabilizer geometry; confirm fit prior to installation and check linkage angles during setup to maintain predictable tail response.

Is this a direct replacement for SSR-VI stabilizer control arms?

The listing specifies SSR-VI compatibility; visually compare mounting points and hole spacing to your helicopter to confirm it will replace your existing arm.

How does this arm influence tuning of the stabilizer?

It establishes linkage geometry that affects tail-centre and the small corrective inputs used during fine tuning, so even small changes can alter stabilizer response.

Will I need extra hardware to install it?

Most installations reuse the helicopter's existing linkage hardware; inspect ball ends and mounting screws for wear and replace any degraded pieces before fitting.

What checks should I perform after fitting the arm?

With power off, move the servo through its range and watch the linkage for binding or excessive play, then verify stabilizer neutral position on the ground prior to flight.

Copyright © 2008-2026 rcjaz.ca All rights reserved