SRX8GTR Rear Carbon Wishbone for SER600077 - Serpent 601402  [SER601402]

Rear carbon arm engineered for SRX8GTR chassis

The Serpent 601402 carbon wishbone rr is an RC-scale rear suspension arm designed to interface with SRX8GTR EC GP SER600077 platforms. Made from carbon fiber, this component delivers a stiff, lightweight replacement that preserves factory geometry while allowing fine control of rear-end response.

Fitment and installation are straightforward when matched to the stated chassis code; verify alignment with existing mount points and reuse the original hardware where feasible. Avoid over-torquing attachment screws and check clearances around the drive components during initial fitting. If replacing a damaged plastic arm, confirm ball stud and hinge pin fit before running the car on-track.

From a setup perspective, the rear wishbone alters toe behavior, roll center characteristics and lateral stiffness. Minor adjustments to arm length or mounting position can change handling balance, so make incremental changes to shock and toe settings and test after each step. Inspect the arm regularly for surface cracks or delamination following heavy impacts.

This carbon wishbone is intended as a direct aftermarket replacement for the specified Serpent chassis, supporting suspension tuning and improved durability without changing the core chassis layout.