SRX8 V2 Suspension Bracket Front/Rear - Serpent 601385  [SER601385]

SRX8 V2 bracket overview and role

This RC-scale suspension bracket is listed as Serpent model SER601385 and is offered as a direct replacement or spare for both front and rear mounting positions on SRX8-series race cars. It performs a structural function that also supports fine suspension tuning by defining attachment points that influence alignment repeatability and wear patterns during club and competitive use.

The part is made to suit SRX8 V2 arrangements while remaining compatible with some SRX8 Gen4 GP assemblies where the mounting layout matches. As a chassis-level element it links to uprights, lower arms, and the shock tower; careful fitment and symmetry are important when swapping brackets to keep handling balanced.

In setup cycles this bracket affects roll centre and camber response under load. Experienced hobbyists fit replacement brackets like this to repair minor chassis damage, test alternate geometry, or restore reliable mounting after extended use. After installation inspect threaded inserts and bore fits to avoid binding that would change suspension response.

Compatibility

• SRX8 V2
• SRX8 Gen4 GP (SER600024)

For racers and builders working on SRX8 platforms, SER601385 is a straightforward replacement option to restore mounting integrity and maintain the intended suspension geometry for consistent setup changes between practice and race sessions.