SRX8 V2 Rear Suspension Bracket - Serpent 601384  [SER601384]

Price:
CAD$37.43
Brand:
Serpent
Model:
SER601384
Condition:
Brand New
Write a review

Replacement rear mount for SRX8 V2

This Serpent 601384 suspension bracket is a direct replacement designed to locate rear suspension links on SRX8 V2 chassis. It provides a rigid mounting point to fine-tune rear roll center and toe without altering existing hub hardware.

Use this bracket when swapping out a worn or damaged rear link mount or when making incremental geometry tweaks during setup. Compatibility is restricted to the chassis codes in the specs below; confirm fit before committing to full assembly.

Specifications

  • Item: Suspension bracket rear RR RR
  • Material: Aluminium
  • Model Number: Serpent 601384
  • Compatibility: SRX8 V2, SRX8 Gen4 GP (SER600024)

Retain original fasteners where possible, verify alignment after installation and adjust rear geometry slowly while testing on-track to assess handling changes.

Will this mount bolt straight onto an SRX8 V2 chassis?

The bracket is listed for SRX8 V2 fitment; check the part orientation and hardware thread engagement on your chassis before final tightening.

What material is used in this bracket?

The specification states Aluminium construction, anodized for surface protection and suitable for typical on-track use and setup work.

Should I reuse the original mounting screws when fitting this bracket?

Where possible reuse the original fasteners; if any are damaged or stripped, replace them with the correct size hex screws from your parts kit.

What handling changes can I expect after swapping this bracket?

Altering the rear bracket shifts the mounting point and can change roll center and toe response. Make small adjustments, then test on-track to judge handling differences.

Copyright © 2008-2026 rcjaz.ca All rights reserved