SRX8 Gen4 Nylon Brake Lever Set - Serpent 601371  [SER601371]

Nylon brake lever kit tailored for SRX8 Gen4

This Serpent 601371 nylon brake lever kit is an RC-scale replacement intended specifically for SRX8 Gen4 brake assemblies. The nylon construction delivers predictable flex and improved wear characteristics compared with fatigued plastic levers.

Compatibility is limited to the SRX8 Gen4 geometry referenced in the product name, so confirm your chassis uses the same brake bell crank arrangement before fitting. Installation is simple: remove the old lever from the brake assembly, transfer any retaining pins or hardware, install the nylon lever in the original orientation, and verify smooth travel across the full brake linkage range.

During setup and tuning, nylon levers will influence pedal feel and modulation and are commonly fitted as like-for-like replacements during maintenance or when restoring even brake actuation. After installation, check for free rotation with no binding and re-check link clearances after a short test run.