SRX8 Gen4 GP Shock Spacer for Ride-Height and Travel Tuning - Serpent 601357  [SER601357]

Spacer purpose and compatibility

The Serpent 601357 shock spacer is an RC accessory made for the SRX8 Gen4 GP chassis family. It is a simple suspension tuning component that changes stack height or preload location on the shock to alter ride height and available travel without modifying spring rates or damper internals.

The spacer gives a compact way to refine handling: shifting the spacer within the shock stack changes leverage and effective ride height, which helps balance front-to-rear weight transfer and sharpen turn-in on different track surfaces. This guidance applies to RC model setup only.

Installation guidance (general):

• Verify the spacer aligns with the shock shaft and upper/lower shock mounts on the SRX8 Gen4 GP before final assembly.
• Reassemble the shock with the spacer in the chosen position, then check static ride height and full travel to confirm no binding occurs.
• After initial fit, run short tests and move the spacer in small steps to observe handling changes rather than making large jumps.

Tuning notes:

• Small spacer increments deliver subtle handling shifts - use them for fine balancing rather than wholesale setup changes.
• Use spacer adjustments together with spring and damper tuning for targeted results, and record each change so you can return to previous settings if needed.