SRX8 Gen4 Front and Rear Shock Boots - Serpent SER601358  [SER601358]

SRX8 Gen4 Shock Boot Protection

The SER601358 set supplies front and rear shock boots made for the SRX8 Gen4 platform. These boots cover the shock body and shaft to limit dust and debris from reaching the seals and inner surfaces, helping to minimise wear between services.

Fitting is simple: push each boot down over the shock shaft from the top, seat it against the shock cap or spring retainer, then cycle the suspension through full travel to confirm there is no binding. After installation, check clearance around the springs, collars, and retainers to ensure normal movement.

When tuning or maintaining the car, these boots keep contaminants away from seals and shafts so damping stays more consistent over consecutive runs and you spend less time on teardown and service.