SRB Scale Washout Linkage HI0312003 - Hirobo  [HI0312003]

HIROBO 0312-003 SRB SCALE WASHOUT ASSEMBLY #0312003
Price:
CAD$8.67
Brand:
Hirobo
Model:
HI0312003
GTIN:
4512895155162
Condition:
Brand New
Write a review

SRB washout component overview

This RC-scale accessory is made for SRB series rotorcraft maintenance and setup. The HI0312003 washout assembly supplies the mechanical linkage that sets washout geometry, enabling finer cyclic response when adjusting pitch and mix on scale-model helicopters.

Installation normally means removing the existing washout linkage from the SRB head, setting linkages to neutral travel, and confirming there is smooth movement through the full control range. Use common hobby tools and verify ball joint seating and any free play before attempting flight.

When tuning, this part changes how cyclic inputs convert into blade pitch across the swashplate, so adjust linkage lengths and collective mixing in small increments. The component is intended and described solely as an RC-scale accessory for model helicopters.

How do I replace the washout on an SRB head?

Remove the original linkage, fit the HI0312003 in the same mounting points, then align the linkages so the swashplate and head are neutral before securing. Check each ball joint for correct seating.

What tools should I use for fitting?

Basic hobby tools are sufficient: hex drivers, pliers, and a small screwdriver. Work on a stable bench and avoid over-tightening linkages to preserve free movement.

Any checks before the first test hover?

Confirm neutral positions, eliminate any binding in the head, and verify cyclic travel. Make incremental trim adjustments on a test bench before flight.

Copyright © 2008-2026 rcjaz.ca All rights reserved