Slash 4x4 Rear Stainless CVD Joint SSLA1277A/JT by GPM  [SSLA1277A/JT]

Rear CVD replacement for Slash 4x4

Aftermarket stainless steel replacement joint for 1/10 scale RC applications, made to serve the rear CVD drive shaft connection. Supplied as a 3 pcs set and intended as a direct replacement for the matching part.

Compatibility notes: this joint is produced to replace the joint end for part #SSLA1277RHA and is not guaranteed to fit other drives or chassis without confirmation. Verify fitment on your rear driveline before installation.

Materials and use: stainless steel construction gives improved strength and better resistance to corrosion compared with basic alloy replacements, helping the joint resist wear during off-road and street bashing. Use this part when a robust rear drive connection is required for repair or modest tuning.

Fitting advice: the part replaces the end section of the rear CVD shaft; standard rear driveline disassembly is required to remove the old component and refit the new unit. Use correct thread engagement and light torque on the small fasteners to avoid stripping, and confirm alignment and free rotation after assembly.

Included items in package and counts as supplied by source: joint - 1 pcs, hex - 1 pcs, 3x3 screw shaft - 1 pcs, supplied as a 3 pcs set.