Serpent SRX8 Gen4 GP Shock Bottom Cap Replacement - SER601356 for Serpent SRX8 Gen4 GP (SER600024)  [SER601356]

Serpent SER601356 Shock bottom cap
Price:
CAD$8.09
Brand:
Serpent
Model:
SER601356
Condition:
Brand New
Write a review

Lower shock cap for SRX8 Gen4 service

The Serpent SER601356 shock bottom cap is an RC spare made to work with Serpent SRX8 Gen4 GP (SER600024) shock units. It replaces the lower end of the shock body to restore proper sealing and serviceability after wear or damage, letting you get back to running quickly.

Fitting is simple for anyone used to threaded shock caps: remove the damper from the car, drain or contain oil if needed, then swap the bottom cap while keeping shims and o-rings in place. Verify the seal and oil level before refitting the shock to the chassis. The part is intended for hobby use on 1/10 touring car platforms and should be serviced in a dedicated RC workspace.

For routine shock work the bottom cap improves service access and sealing rather than directly changing damping curves; replace it when wear or leaks impair consistent suspension performance.

Compatibility

Compatible with: Serpent SRX8 Gen4 GP (SER600024).

What are the basic steps to install the SER601356 bottom cap on an SRX8 Gen4 shock?

Start by removing the shock from the car, secure the piston rod, drain or catch oil, unscrew the old cap, fit the new SER601356 cap while keeping internal shims and o-rings in place, then refill and check for leaks before reinstalling.

Do I need any special tools to change the bottom cap?

No special tools are required beyond common RC workshop items such as small wrenches, shock pliers or a soft-jawed vise and clean containers for shock oil.

Should I replace shock oil when swapping the bottom cap?

Inspect the oil and seals; if oil is contaminated or seals are disturbed during the swap, refresh the fluid to maintain consistent damping and prevent premature wear.

Copyright © 2008-2026 rcjaz.ca All rights reserved