Serpent 804383 17T Aluminum Pinion for Centax-3 Racing  [SER804383]

Serpent SER804383 Centax-3 gear-pinion Aluminium 17t wc V2
Price:
CAD$18.32
Brand:
Serpent
Model:
SER804383
Condition:
Brand New
Write a review
alt="Serpent SER804383 Centax-3 gear-pinion Aluminium 17t wc V2" title="Serpent SER804383 Centax-3 gear-pinion Aluminium 17t wc V2"
alt="Serpent SER804383 Centax-3 gear-pinion Aluminium 17t wc V2" title="Serpent SER804383 Centax-3 gear-pinion Aluminium 17t wc V2"

Boost Track Performance with Serpent 804383 17T Aluminum Pinion

The Serpent 804383 Centax-3 gear-pinion is a precision-crafted accessory made to sharpen an RC car's drivetrain. Machined from quality aluminum, this 17-tooth pinion balances weight and strength to stand up to race conditions while helping maintain smooth acceleration and control.

Why pick aluminum for pinions?

Aluminum offers a useful compromise between rigidity and low mass, helping your drivetrain resist wear without dragging down handling. That balance helps preserve throttle response and steering consistency during tight laps. The Serpent 17T pinion leverages these material benefits for repeatable gear engagement.

Built for racers focused on consistency

This gear-pinion is targeted at drivers who tune setups for predictable lap times. Easy to fit into Centax-3 drives, the Serpent 804383 works well when you are fine-tuning gear ratios or preparing a car for heat racing.

Which vehicles use this pinion?

This pinion is made for cars that use the Centax-3 gear system. Verify your gearbox spec to confirm fitment.

How do I set the gear mesh correctly?

Use a thin paper or feeler method to set a small clearance, tighten the pinion, then recheck after a short break-in run to avoid binding.

Is the pinion suitable for off-road surfaces?

Yes, it performs well on loose surfaces but you should clean and inspect the gear after dusty or muddy sessions to prevent premature wear.

Copyright © 2008-2025 rcjaz.ca All rights reserved