Serpent 601286 105.5mm Drag Driveshaft for Cobra SRX8 [SER601286]

Serpent SER601286 Driveshaft center 105,5mm Drag Racing

Price:

CAD$22.09

Brand:

Serpent

Model:

SER601286

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

105.5mm Drag Driveshaft Built for Tough Use

The Serpent 601286 driveshaft is engineered to lift the straight-line performance of Cobra SRX8 GT and GTE models. Measuring 105.5mm, it is made to cope with the high loads of drag starts while keeping power delivery accurate and repeatable. Whether fitting an upgrade or replacing a worn part, this driveshaft helps maintain reliability on race day.

Main Benefits for Racers

Precision Engineering: Tailored to the Cobra SRX8 GT and GTE to ensure correct alignment and steady torque flow.
Racing Performance: Built to tolerate the repeated shocks and loads typical of drag launches for consistent results.
Durability: Constructed from hard-wearing materials to limit wear and extend service intervals.

Will this fit older Cobra SRX8 variants?

Compatibility is focused on the Cobra SRX8 GT and GTE. Some older SRX8 variants may require checks to verify shaft length and spline fit before installation.

How often should I inspect the driveshaft for wear?

Inspect the driveshaft after any heavy run or crash and as part of routine maintenance every few events to catch wear at the splines or shaft ends.

Any setup tips for drag starts with this shaft?

Check driveline alignment and use smooth throttle application during break-in runs; proper pinion and spur mesh helps reduce shock on the shaft at launch.