Serpent SER500888 13mm Front Shock Body Replacement  [SER500888]

13mm front shock body for Serpent assemblies

This RC-scale front shock body is a replacement or service component for Serpent shock assemblies that use a 13mm outer-diameter shock tube. The housing influences oil volume, piston travel and sealing performance in typical 1/10 scale touring and on-road setups.

Practical notes for installation and setup:

• Confirm your shock uses a 13mm outer diameter body before ordering to ensure correct fit with Serpent shock caps and shafts.
• When removing the old body, drain the oil and inspect pistons, shafts and seals for wear so they can be serviced or replaced as needed.
• Use compatible shock oil and set the oil level and bleed precisely; small changes to oil height change low-speed and high-speed damping behavior.
• Check O-rings and thread engagement during reassembly to avoid leaks and maintain consistent rebound.

The part is strictly for RC model use and should be handled as a model-scale shock component during maintenance and tuning.

A practical replacement for Serpent 13mm front shock applications, intended to restore or fine-tune front damping on hobby-grade 1/10 scale cars.