This RC accessory is a pack of eight body clips made for the Serpent Mini Spyder MT platform, referenced to the Mini Spyder Monster truck RTR EP (SER440001) chassis. Each clip offers a straightforward mechanical retention method for the polycarbonate body, keeping the shell in place during off-road runs while still allowing rapid removal for battery or electronics service.
Fitting is simple on standard body posts: align the body hole with the post, push the clip through the post slot until it seats, and check that the body edge is held. To remove, pinch the clip and pull it clear of the post. No special tools are required for routine use.
In practice these clips help in two ways during setup and tuning: they hold the body securely to avoid snagging or unwanted movement under rough conditions, and they permit fast access to internal components when adjustments are needed between runs. The pack contains 8 pcs to cover typical small truck mounting layouts and provide spares.
Copyright © 2008-2026 rcjaz.ca All rights reserved
