Medius X26 Rear Lower Wishbone Steel Replacement - 402172 Serpent  [SER402172]

Rear lower wishbone tailored for Medius X26 steel EP

The Serpent 402172 rear lower wishbone for X26 is an RC-scale rear lower arm engineered for the Medius X26 steel EP chassis family (SER400052). It is offered as a direct spare or replacement for the rear suspension layout, retaining the original mounting points and attachment geometry to ensure correct fit on the Medius X26 platform.

Constructed from steel as indicated in the product designation, the component functions as a structural link between the hub carrier and lower suspension members. When replacing a worn arm, align ball studs and pivot points carefully to preserve roll center and suspension kinematics.

Installation notes: verify thread engagement on all fasteners and apply threadlocker where the chassis setup requires it; torque to the values specified in your Medius X26 service documentation. After fitting, perform a static check of suspension travel and a short functional test to confirm no binding or unexpected play.

Tuning role: the lower wishbone influences lateral stiffness and pivot behavior; swapping between original and steel parts can change feedback and durability. Fit this steel arm when restoring factory geometry or when increased wear resistance is needed for high-impact running.

Fit the Serpent 402172 wishbone to preserve the rear suspension geometry on the Medius X26 steel EP chassis, and carry out routine checks after installation to maintain consistent handling.