Serpent 401662 Aluminum Roll Damper Holder - 4-X Chassis Upgrade  [SER401662]

Serpent SER401662 Roll Damper Holder Aluminium 4-X (2)
Price:
CAD$71.09
Brand:
Serpent
Model:
SER401662
Condition:
Brand New
Write a review

Precision Aluminum Damper Mount for 4-X Chassis

The Serpent 401662 Aluminum Roll Damper Holder is a precision-machined item built for the 4-X chassis. Machined from quality aluminum, this holder increases part longevity while giving racers more tuning options for consistent lap times.

Benefits of Aluminum in Race Components

Aluminum parts are prized for being lightweight yet strong. The Serpent 401662 roll damper holder uses those traits to deliver a stable mounting point for your dampers, helping maintain predictable handling and limiting wear under hard use.

Fitment and Straightforward Installation

This roll damper holder is made specifically for the 4-X chassis so fitment is accurate and installation is straightforward. Whether swapping in upgrades or replacing tired stock parts, this aluminum holder is built to stand up to competitive track demands.

Will this mount work with aftermarket dampers?

The Serpent 401662 is designed to accept standard roll dampers used on the 4-X chassis. Check damper shaft diameter and eyelet spacing to confirm fit before purchase.

What hardware do I need to install it?

The package contains two aluminum roll damper holders only. You will typically need small machine screws and washers that fit your chassis; source these based on your existing setup.

Does this affect roll stiffness or handling?

Mounting position and damper selection determine roll behaviour. Using the Serpent 401662 gives a firmer, more consistent mount which helps you tune roll response via damper choice and mounting offset.

Copyright © 2008-2025 rcjaz.ca All rights reserved