Serpent Medius X26 Rear Body Plate Graphite - O-SPP010 by Factory Pro  [FP-O-SPP010]

Graphite rear plate for Serpent Medius X26

This replacement rear body plate is an RC-scale hop-up made by Factory Pro for the Serpent Medius X26 chassis. The part is listed as Factory Pro O-SPP010 and comes in a graphite finish to match the vehicle's rear body mounting points.

Its role is a direct-replacement body mount panel and a small tuning element where added stiffness or slight mass at the rear can affect handling balance. It is intended for hobby use on the Medius X26 platform and should be installed using the car's original mounting locations and hardware.

Fitting on the Medius X26 is straightforward: remove the damaged plate, check mounting post alignment, reuse the original screws or fasteners, and ensure clearance around the suspension and motor. After fitting, confirm the body sits true and that there is no contact with suspension travel or rear gearbox parts.

Care tips: inspect the graphite plate for impact damage after crashes, keep mounting faces clean, and retorque fasteners after the first run to achieve correct seating. Use this item to restore original rear body geometry following damage.