Serpent Medius X26 Graphite Bulkhead Brace for Tuning - O-SPP004 by Factory Pro  [FP-O-SPP004]

This graphite bulkhead brace is made by Factory Pro for the Serpent Medius X26 and serves as an aftermarket reinforcement part for RC touring cars. It fits at the Medius X26 bulkhead area to modify chassis response during cornering and quick direction changes.

The brace provides added localized stiffness at the bulkhead junction. That shift in flex characteristics lets drivers fine-tune the balance between front and rear grip without altering suspension geometry. Use it as a controlled setup change to chase more consistent lap times and stronger mid-corner stability.

Installation is straightforward for hobbyists familiar with Medius X26 teardown: remove the body where required, unfasten the existing bulkhead screws, position the graphite brace and secure with the original hex screws. After tightening, recheck clearance for driveshafts and linkages.

Compatibility is limited to the Serpent Medius X26 chassis only; verify your chassis code before ordering to avoid mismatches. This item is an RC-scale component and is not suitable for any full-size vehicle use.