Serpent 500889 13mm Rear-Right Shock Body for RC Dampers  [SER500889]

Rear-Right 13mm Shock Body

This RC-scale shock body is a replacement sleeve for the rear-right damper assembly. It locates internal shock parts during disassembly and reassembly, and is used when servicing or rebuilding dampers on remote-controlled cars.

Fit this part when inspecting internals, replacing a damaged sleeve, or refining damping behavior during setup. The component focuses on housing and alignment rather than altering damping characteristics by itself, so tuning remains a combination of piston, shaft, spring and fluid selection.

Installation notes: remove the shock from the vehicle, drain shock fluid, disassemble the shock cap and internals, swap in the body, then reassemble while checking for smooth shaft movement and correct seal seating. Verify stroke and clearance before final fitment to the suspension arm.