Serpent 4X FWD Carbon Chassis Plate 2.25mm - Arrowmax AM-920031  [AM-920031]

Chassis summary

This carbon front wheel drive chassis plate is produced by Arrowmax as AM-920031 and is intended for Serpent 4X platforms and Project 4X variants. The plate has a nominal thickness of 2.25mm and is intended to modify chassis flex and handling rather than change the vehicle architecture.

Setup use: the component is offered as a replacement or tuning hop-up for cars sharing the Serpent 4X mounting pattern, providing a firmer baseline compared with thinner stock plates. Swapping to this carbon plate will alter flex characteristics and influence turn-in, mid-corner balance, and stability at speed on on-road surfaces.

Fitting notes: the plate matches Serpent 4X mounting geometry so it is designed to install in place of the original chassis plate without redesign; still confirm motor mount, servo and suspension pickup alignment before final assembly. Check fastener torque and thread engagement during installation to avoid binding in drivetrain or steering linkages.

For racers aiming to refine front-end behaviour on Serpent 4X based kits, the Arrowmax AM-920031 carbon chassis plate raises chassis stiffness in a predictable way to help dial in on-road FWD handling.