TRAXXAS Slash 4x4 Front and Rear CVD Screw Pins SSLA1277RHP by GPM  [SSLA1277RHP]

Slash 4x4 front and rear CVD pin replacements

This aftermarket set is a simple RC-scale accessory intended to stabilise the front and rear CVD drive shaft joints on TRAXXAS Slash 4x4 models. It is supplied as a 2 pcs replacement set to match the original screw-pin function used in the Slash F/R CVD yoke.

The pins maintain axial and rotational position inside the CVD assembly, helping to reduce end play and keep driveshaft engagement consistent under load. Fit these where the original pins show wear, bending, or excess play that affects driveline behaviour.

Fitting is straightforward for experienced technicians: remove the CVD assembly, replace the worn pin with the new unit, and reassemble following the vehicle's original fastening method. The part is a direct RC-scale replacement designed to interface with the Slash F/R CVD components stated in the product title.

Tuning note: these pins are a modest reliability hop-up; they do not change gear ratios or motor output but help preserve steady power transfer by holding CVD components correctly during heavy use.