Scorpion SPS3014MSK 5mm Shaft Kit for S-3014 Outrunner Motors  [SPS3014MSK]

S-3014 Shaft Replacement Overview

This shaft kit is a direct replacement intended for the Scorpion S-3014 series outrunner motors. The 5mm shaft matches the S-3014 motor geometry so the shaft seats into the existing bearing bores and aligns with the motor pinion and spur arrangement used across the S-3014 family.

Fit this kit when a motor shows axial play, excessive runout, or when the original shaft is worn or damaged. Replacing the shaft restores alignment, helps reduce uneven bearing wear, and can improve smoothness when bearings are inspected and serviced as part of the repair.

Installation notes: the kit is made for direct fit into S-3014 outrunner assemblies and works with the original internal layout. Ensure the shaft seats fully in the bearing journal and that pinion engagement is correct before final assembly. After fitting, check for free rotation and minimal wobble at low-speed rotation before reinstalling the motor into the model.