Scorpion SPS3008MSK Outrunner Motor Shaft Kit 5mm for S-3008 Series  [SPS3008MSK]

S-3008 shaft service and swap

This Scorpion SPS3008MSK shaft kit is a direct replacement option for the Scorpion S-3008 series outrunner motors. It is intended to replace a worn, bent, or damaged factory shaft and matches the 5mm diameter used in these motors.

Use the kit for maintenance and repair: remove the motor endbell, inspect the shaft and bearings for scoring or play, install the new shaft, and reassemble while checking for runout and bearing alignment. Proper reassembly helps reduce vibration and extends bearing life in RC brushless motors.

After replacing the shaft, confirm the rotor spins freely without binding and that any pinion or pulley alignment remains correct. This item is supplied as a single replacement shaft for hobbyist servicing and does not include extra hardware.