Schumacher FT9 Rear Body Mount Graphite 3.0 Upgrade - Factory Pro O-SCP040  [FP-O-SCP040]

Price:
CAD$18.83
Brand:
Factory Pro
Model:
FP-O-SCP040
Condition:
Brand New
Write a review

FT9 rear body mount upgrade

This Factory Pro O-SCP040 aftermarket rear body mount is made for the Schumacher FT9 platform as a scale radio-controlled accessory. Machined from Graphite 3.0, the component is intended to deliver consistent body-shell seating and reliable positioning rather than a cosmetic change.

Fit the mount to hold the rear of the body shell while you make fine alignment adjustments during setup. The Graphite 3.0 material balances light weight with enough stiffness to help the shell sit predictably relative to the chassis for aerodynamic checks and clearance verification on the circuit.

Installation is straightforward for those familiar with FT9 assemblies: remove the original body mount hardware, align the mount with the factory mounting points on the chassis, and reuse the existing fasteners to secure it. After fitting, inspect suspension and body post clearances and confirm the shell is centred left to right before running.

Will the mount fit all Schumacher FT9 chassis versions?

The Factory Pro O-SCP040 is produced for the Schumacher FT9 platform. Check your chassis mounting points and use the original fasteners to confirm fitment before final assembly.

Why choose Graphite 3.0 for this rear mount?

Graphite 3.0 gives dimensional stability with moderate stiffness while keeping weight low, helping the shell sit consistently for small setup changes and repeatable tests.

Any tips to avoid fitment problems during install?

Use the factory mounting points and the original fasteners, torque incrementally, and check for contact with suspension parts and body posts before track use.

Copyright © 2008-2026 rcjaz.ca All rights reserved