Schumacher FT9 Graphite Steering Hub Plate RL - Factory Pro O-SCP038L  [FP-O-SCP038L]

Price:
CAD$12.37
Brand:
Factory Pro
Model:
FP-O-SCP038L
Condition:
Brand New
Write a review

Graphite hub plate for FT9 steering

This Factory Pro aftermarket steering hub plate is an RC-scale replacement made for the Schumacher FT9 platform, supplied as 1 pcs and manufactured in graphite. It is intended as a direct-fit hub plate within the FT9 steering assembly where graphite stiffness and wear characteristics are commonly chosen for scale touring car setups.

Installation notes: check the part orientation against your current hub and the FT9 chassis layout, use your standard RC hex driver set for removal and refit, and inspect mating faces and bearings before final assembly. Keep original mounting hardware when practical and follow your usual torque practice for wheel hub fastenings.

Tuning role: the hub plate serves as a structural mount in the steering geometry; after fitting a graphite plate, monitor any change in steering feedback and linkage alignment, then re-check toe and caster settings. Regularly inspect contact faces and 走珠軸承 to preserve consistent steering behaviour on track.

Will this fit other Schumacher kits with similar hubs?

This part is listed for the FT9. To confirm fit on other Schumacher kits, compare the plate shape and mounting hole pattern with your chassis or contact the seller with photos of your hub area.

What basic tools should I have for installation?

Use a set of RC hex drivers, a small torque driver if available, and clean the mating surfaces and bearings before assembly. A thread locker is optional if you normally use it on hub bolts.

How often should I inspect this graphite plate?

Check the contact faces and 走珠軸承 after several runs or whenever you change suspension setup. Inspect for wear or play and verify wheel alignment after the first few sorties following installation.

Copyright © 2008-2026 rcjaz.ca All rights reserved