Schumacher FT9 Graphite Steering Hub Plate +1mm Offset - Factory Pro O-SCP041L  [FP-O-SCP041L]

Price:
CAD$12.37
Brand:
Factory Pro
Model:
FP-O-SCP041L
Condition:
Brand New
Write a review

FT9 steering plate overview

This Factory Pro O-SCP041L steering hub plate is an aftermarket graphite replacement made for the Schumacher FT9 platform, supplied as a single piece. It adds a +1mm offset to adjust steering geometry slightly, used when fine tuning handling on 1/10 scale electric touring cars.

The hub plate locates at the FT9 steering hub position shown in the part name (RL) and replaces the original hub plate without altering other suspension parts. Graphite construction keeps mass down while giving a firmer mounting point compared with many stock plastics.

Fitting follows standard FT9 hub service steps: remove the wheel and hub assembly, swap in the Factory Pro plate, confirm kingpin and bearing seating, then bench-check toe and steering roll centre before track testing. Make measured changes and adjust one variable at a time when testing offset effects.

Will this fit every Schumacher FT9 variant?

It is designed for the FT9 RL steering hub location as indicated. Check your car's hub layout and part orientation to confirm fit before installing.

How does the +1mm offset change handling?

A +1mm offset shifts scrub radius and steering roll centre slightly, producing a subtle change in turn-in and front feel. Try it on the bench and on the track to decide if it matches your setup goals.

Do I need different bearings or hardware?

Generally the stock bearings and pins remain compatible, but inspect bearing seating and hardware during installation and replace worn items for best results.

Copyright © 2008-2026 rcjaz.ca All rights reserved