This is an aftermarket front-left (FL) hub plate made to fit the Schumacher FT9 1/10 touring car platform, supplied as one piece for direct replacement. The graphite construction changes stiffness characteristics compared with stock plastic parts and is aimed at hobby tuners refining steering feel and balance.
Installation is straightforward for anyone used to FT9 front-end work: remove the original hub plate, transfer pins or bearings as needed, and refit using your original hardware. No special tools beyond standard hex drivers and basic hand tools are required; ensure screws are correctly engaged and bearings sit true to prevent binding.
Tuning note: swapping the stock plate for a graphite unit shifts local rigidity and resonance. Expect modest changes in steering feedback and response rather than drastic handling changes; make adjustments one item at a time and test for differences in understeer, oversteer, and steering consistency.
Made to match Schumacher FT9 mounting points, described as a front-left steering hub plate, sold as a single piece, and intended for RC touring car applications only.
Copyright © 2008-2026 rcjaz.ca All rights reserved
