Schumacher FT9 Front Steering Hub Plate Graphite - Factory Pro O-SCP037  [FP-O-SCP037]

Price:
CAD$17.28
Brand:
Factory Pro
Model:
FP-O-SCP037
Condition:
Brand New
Write a review

FT9 front steering hub plate

This Factory Pro front steering hub plate is made for the Schumacher FT9 and is supplied as one pair in graphite. It serves as an RC-scale replacement at the front steering knuckle to support steering linkages and keep hub alignment on the FT9 chassis.

Graphite gives a mix of stiffness and low weight without promising specific performance gains; installers should fit this plate in place of the original front hub plate, verify bearing alignment and hex screw seating, and check steering geometry before running. The part is intended for use with standard FT9 steering components and typical servo set ups.

Fit this plate when you need to refresh a worn hub plate or when dialing steering feel, keeping installation within normal RC workshop practice and avoiding changes to the original mounting points.

Will this hub plate fit the stock FT9 front knuckle?

Yes, the Factory Pro O-SCP037 is shaped to replace the stock front hub plate on the Schumacher FT9 without needing new mounting holes.

Do bearings and screws come with the pair?

The listing states one pair of graphite plates only; bearings, hex screws or other hardware are not guaranteed and should be fitted from your existing parts or purchased separately.

How does graphite affect steering feel?

Graphite reduces flex compared with some plastics at the mounting point, helping to keep steering geometry more consistent during tuning and longer runs.

Copyright © 2008-2026 rcjaz.ca All rights reserved