Schumacher FT9 Front Lower Arm - Direct Replacement Factory Pro O-SCP039F  [FP-O-SCP039F]

Front lower arm details

This is a Factory Pro aftermarket replacement lower suspension arm for the Schumacher FT9 touring chassis, supplied as 1pc. It installs as a direct-fit front lower arm used for routine maintenance and setup tuning on FT9-class RC touring cars.

Intended use: replace a worn or damaged stock front lower arm, verify fitment at the suspension ball stud and pivot pin locations during installation, and recheck alignment and roll centre after swapping parts. This arm is an RC component and is not intended for full-size vehicle use.

Installation notes: remove the front wheel and hub assembly to reach the lower arm mounting, inspect existing pivot hardware and bushings, fit the new arm in the original orientation and torque fasteners to your chassis service recommendations. After fitting, confirm steering geometry and suspension travel on a stand before track running.

Fitment

Compatible chassis: Schumacher FT9.