This RC-scale stabilizer stopper is a replacement tail component for the SCEADU FZ-V platform, designed to limit stabilizer travel and assist in setting neutral and end positions in the tail assembly.
The part acts as a mechanical stop within the tail linkage area, providing repeatable positioning for adjustments and routine maintenance. It is intended for model-level use only and is not suitable for full-scale aircraft.
Installation is straightforward for hobbyists familiar with tail-case access: remove the tail cover, position the stopper on the stabilizer or linkage per the model's service layout, and secure using the existing mounting holes and screws. Small positional adjustments allow fine tuning of tail responsiveness and centring.
During setup workflows this stopper is used to constrain travel, prevent servo over-travel on tail mechanisms, and give a consistent reference when trimming or setting servo end points.
Copyright © 2008-2026 rcjaz.ca All rights reserved
