RP Sensor Lead 200mm for Brushless Motors - Yokomo YOKRP-012  [YOKRP-012]

RP 200mm sensor lead overview

The Yokomo YOKRP-012 Racing Performer sensor wire is a simple replacement or extension lead for RP-series sensor-equipped brushless setups. At 200mm, the cable gives a predictable length for tidy routing between a sensor-equipped motor and an ESC or junction inside touring, drift, or competition electric cars.

Use this lead when swapping out a damaged sensor cable or when you want a repeatable length for consistent installation and setup work. Keep the sensor cable separated from high-current power wiring to reduce interference, secure routing with small ties or clips, and avoid sharp bends close to soldered joints. Only trim extra length after final component placement to preserve signal integrity.

Installation notes: route the lead along existing chassis channels where possible, use heat-shrink over soldered joins to prevent shorts, and verify connector orientation before final assembly. The wire is a passive connection and will not alter electronic timing or motor parameters by itself, but clean sensor contacts are important for smooth commutation in sensor-equipped brushless motors.