RC18T/RC18R Rear 0 Degree Aluminum Toe-Out Mount RC18-016/SI by 3Racing  [RC18-016/SI]

Rear toe-out mount for RC18T/RC18R chassis

This aluminum rear toe-out mount is an aftermarket replacement for Team Associated RC18T and RC18R chassis, offering a fixed 0 degree toe-out reference for the rear hub assembly. It is intended for accurate tuning and repeatable setup on 1/18 scale racing models.

The part follows the RC18T/RC18R mounting pattern and gives a firmer mounting point than typical plastic mounts, helping rear toe remain consistent under load. Its metal construction is aimed at improved stability during aggressive running.

Installation uses the original rear hub mounting points and stock hardware; fitment is straightforward. Tighten fasteners to a moderate torque to protect threads and verify alignment after the first test runs since the mount fixes the geometry rather than providing adjustment.

Use this mount when you need a repeatable 0 degree rear toe-out for baseline checks or progressive setup changes, and inspect for any burrs or loosened fasteners after track use to retain predictable handling.