R/C 13mm Shock Spring 3.6lbs Serpent 500907  [SER500907]

Price:
CAD$0.00
Brand:
Serpent
Model:
SER500907
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Spring specification and intended use

This Serpent 500907 spring is an RC-scale shock spring specified as 13mm with a 3.6lbs rate and pink finish, intended for use in R/C general suspension setups. It serves as a replacement or spare where 13mm coil springs are required.

Installation notes: install the spring onto the shock shaft and seat it on the spring retainer according to your shock design, check that the spring runs true without binding before final assembly, and adjust preload gradually to reach the desired ride height and balance.

Tuning role: the 3.6lbs rate makes the suspension firmer compared with softer options, reducing roll and improving response on landings; apply small incremental changes and test drive to find the balance between traction and agility.

What does the 13mm size indicate for fitment?

The 13mm figure denotes the spring's nominal coil diameter intended for shocks that accept 13mm springs; match this to your shock's retainer and shaft dimensions for correct fit.

How will a 3.6lbs spring change handling on track?

Expect reduced body roll and quicker recovery after jumps with a 3.6lbs spring; however, on very rough surfaces the firmer rate can decrease mechanical grip, so tune shocks and driving style accordingly.

Any practical fitting tips to avoid binding?

Make sure the spring seats squarely on the retainer, confirm the shaft moves freely through the spring's center, and increase preload in small steps while checking full shock travel.

Copyright © 2008-2026 rcjaz.ca All rights reserved