RADTEC RAD-MA-10006 150mm Flat Bonded Flex Sensor Wires - Low Profile  [RAD-MA-10006]

RAD-MA-10006 150mm FLAT BONDED Flex Sensor Wires
Price:
CAD$4.45
Brand:
RADTEC
Model:
RAD-MA-10006
Condition:
Brand New
Write a review

Low Profile Sensor Wiring for Clean Builds

Built for RC hobbyists who tune brushless systems, the RADTEC RAD-MA-10006 150mm flat bonded flex sensor wires deliver steady signal paths between motor and ESC to improve throttle feel and timing. The flat bonded construction reduces bulk and helps keep wiring neat under bodywork.

Durable Flat-Bonded Design

The 150mm length is long enough for most chassis layouts while staying flexible for tight routing. The flat bonded finish increases abrasion resistance and reduces the chance of intermittent contacts during aggressive runs.

Practical Use Cases

These sensor leads suit on-road racers, buggies and short-wheelbase trucks where space is limited and reliable feedback is important. They are a practical upgrade for anyone needing a tidy sensor connection that stays put when the going gets rough.

Will these fit a 540-size brushless motor?

They are compatible with most standard sensored brushless motors that use small three-pin sensor headers. Confirm your motor's connector style before fitting.

Are they easy to hide in touring car layouts?

Yes, the flat profile makes them easy to tuck along chassis rails or under the servo tray, helping maintain a low and tidy wiring run.

Any tips for installation and strain relief?

Use small heatshrink at connector joints and secure with a gentle tie or adhesive pad to prevent sharp bends and reduce stress on the sensor pins.

Copyright © 2008-2026 rcjaz.ca All rights reserved