RADTEC RAD-MA-10005 110mm Flat Bonded Flex Sensor Wires - Service Grade  [RAD-MA-10005]

RAD-MA-10005 110mm FLAT BONDED Flex Sensor Wires
Price:
CAD$4.45
Brand:
RADTEC
Model:
RAD-MA-10005
Condition:
Brand New
Write a review

Dependable Signal Link with RADTEC RAD-MA-10005

RC hobbyists who need a reliable link between sensored brushless motors and ESCs will appreciate the RADTEC RAD-MA-10005 110mm flat bonded flex sensor wires. The flat bonded profile keeps the wiring low and tidy while maintaining consistent signal transfer for telemetry and motor timing.

Built for Brushless Motor Setups

The RAD-MA-10005 wires are made to work with sensored brushless systems, giving a flexible yet secure connection. The flat bonded layout helps prevent snags and disconnections during fast runs or off-road use, making it suitable for both competition and casual use.

Swap-Friendly Length and Ease of Use

These sensor wires suit frequent motor or ESC swaps thanks to their straightforward plug-and-play approach. At 110mm they offer enough reach for most standard model layouts while avoiding excess slack that can catch on chassis parts.

Will these fit most sensored brushless motors and ESCs?

They are compatible with the majority of standard sensored brushless motor and ESC setups, but you should confirm the connector type and pin order for your specific equipment before installing.

How robust is the flat bonded construction?

Flat bonding gives added flexibility and helps reduce abrasion compared with loose wires, but care should be taken to route them away from sharp edges and hot parts to extend service life.

Can I trim and re-terminate the wires if needed?

Yes, trimming and re-terminating is possible if you are comfortable with soldering; maintain correct wire order and insulation to avoid signal or grounding issues.

Copyright © 2008-2026 rcjaz.ca All rights reserved