RADTEC RAD-MA-10004 90mm Flat Bonded Flex Sensor Wires Low-Profile Leads  [RAD-MA-10004]

RAD-MA-10004 90mm FLAT BONDED Flex Sensor Wires
Price:
CAD$4.45
Brand:
RADTEC
Model:
RAD-MA-10004
Condition:
Brand New
Write a review

Sturdy sensor leads built for tidy motor to ESC connections

RC builders looking for dependable sensor wiring will find the RADTEC RAD-MA-10004 90mm Flat Bonded Flex Sensor Wires a handy choice. These flat bonded leads are made to keep signal paths stable between brushless motors and ESCs while fitting into cramped electronics bays.

Practical design for tight installations

The slim, flexible construction lets you route the RAD-MA-10004 wires around frames and inside compact chassis without stress. Their bonded layout helps keep wires flat and reduces unwanted movement for consistent sensor readings.

Works across common RC setups

From lightweight on-road rigs to modified scale trucks, these sensor wires provide tidy connections that support accurate motor control. The flat profile also helps minimise electromagnetic interference for cleaner feedback to the ESC.

Are these wires compatible with common brushless motors and ESCs?

They are compatible with most standard brushless motors and ESCs that use sensor leads. Check your motor and ESC connector type before fitting to be sure of a match.

How should I route the sensor wires inside a tight chassis?

Keep the flat side against chassis surfaces and avoid sharp bends. Use small cable ties or adhesive tape to secure the wires and prevent them rubbing on moving parts.

Do these wires need special maintenance?

Inspect connections and insulation regularly, especially after crashes. Re-seat connectors and replace any wire showing exposed conductors or intermittent readings.

Copyright © 2008-2026 rcjaz.ca All rights reserved