RADTEC RAD-BB-20001 10x15x4mm Ceramic Ball Bearings Red Seal Set of 4  [RAD-BB-20001]

RAD-BB-20001 10x15x4mm Ceramic Ball Bearing, 4 pcs, Red Rubber Seal
Price:
CAD$33.73
Brand:
RADTEC
Model:
RAD-BB-20001
Condition:
Brand New
Write a review

Performance Upgrade with RADTEC Ceramic Bearings

If you want cleaner operation and increased reliability for your RC car, the RADTEC RAD-BB-20001 ceramic ball bearings are a practical upgrade. This set contains four 10x15x4mm bearings fitted with red rubber seals to minimise contamination and keep rotation smooth.

Benefits of Ceramic Bearing Construction

Ceramic bearings run with lower friction and resist wear better than typical steel bearings, which can help maintain speed and reduce heat buildup during intense runs. The red rubber seal gives extra protection against dirt and moisture so service intervals can be extended.

Where to Install These Bearings

These 10x15x4mm bearings work well in many 1/10 scale applications, including wheel hubs, gearbox shafts and idler locations. They are a straightforward replacement for worn steel bearings and can improve throttle response and steering feel across different chassis layouts.

How do these bearings affect run time and speed?

Low friction ceramic balls reduce drivetrain resistance, which can translate to slightly improved top speed and more efficient power transfer, though gains depend on the rest of your setup.

Are the red seals removable for cleaning?

The seals provide protection during use; if you need to deep clean, check the seal design before removing to avoid damaging the bearing. Routine maintenance usually involves light cleaning and relubrication.

Will these fit my 1/10 off-road buggy?

If your buggy uses 10x15x4mm bearings in hubs or shafts, the RAD-BB-20001 set will fit as a direct swap. Verify the bearing seat dimensions on your model before installation.

Copyright © 2008-2026 rcjaz.ca All rights reserved