RADTEC RAD-AC-10019 3x5.5x2.0mm Red Aluminum Spacer Set, 10 Pieces  [RAD-AC-10019]

Small Aluminum Spacers for Accurate Setup

The RADTEC RAD-AC-10019 spacer set gives hobbyists a simple way to refine the setup of their RC cars. These 3x5.5x2.0mm red aluminum spacers are made from lightweight aluminum to add minimal mass while offering durable, repeatable spacing. Ten pieces are included so you can address multiple mounting points or spare parts needs.

Compatibility and Typical Uses

Use these spacers to tweak wheel offset, adjust suspension link spacing, or fine-tune chassis clearances. Their compact 3x5.5x2.0mm size fits many common bolt and shaft setups found on 1/10 scale and similar RC machines, though fit should be checked against your specific hardware.

Maintenance and Visibility

The red anodized finish helps you spot spacers during assembly and reduces oxidation over time. They are easy to clean and inspect during routine maintenance, making them a handy part for regular setup sessions and track-side adjustments.