Outlaw Rampage PRO 2.0 Offset Rod End for Steering Adjustment - Kyosho OL045  [KY-OL045]

Fine-adjust offset rod end

This offset rod end is an RC-scale linkage component intended for use on the Outlaw Rampage PRO 2.0 truck series. It replaces or upgrades the terminal at a linkage rod to allow small changes to steering and suspension geometry while keeping a compact connection point.

Compatibility: the part is designed for use with the Outlaw Rampage PRO 2.0 truck series; inspect your current turnbuckle and rod end thread pattern and overall length to confirm compatibility before fitting.

Installation notes: remove the original rod end from the linkage, thread the new offset rod end onto the turnbuckle or rod, verify the offset orientation relative to the chassis, and secure using the original hardware. Make incremental adjustments and check steering return and suspension travel after each change.

Tuning role: an offset rod end shifts the end-point of a linkage without significantly changing turnbuckle length, enabling precise control of toe, steering throw, and neutral alignment. Use small steps to refine steering feel or to correct minor geometry discrepancies found during setup.

Maintenance: inspect the joint for play, clear any grit from the bearing area, and replace worn rod ends promptly to prevent steering slop and uneven suspension response.