Outlaw Rampage PRO 2.0 Front Suspension Arm V2 - Kyosho OL046  [KY-OL046]

Kyosho OL046 - Front Suspension Arm V2
Price:
CAD$0.00
Brand:
Kyosho
Model:
KY-OL046
GTIN:
4548565522279
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Replacement Front Lower Arm V2

The Kyosho OL046 front suspension arm V2 is a scale RC replacement part made for the Outlaw Rampage PRO 2.0 chassis. It fits as a direct swap for a worn or broken front lower arm and helps recover intended geometry and predictable steering feel on the truck.

In operation, the arm acts as a structural link in the front suspension, positioning the wheel hub and controlling camber and toe under load. The V2 tag denotes a later revision aimed at matching factory geometry and fit without chassis modification.

Installation notes: remove the front wheel and lower-arm mounting hardware, transfer any bushings or pins from the original arm where appropriate, install the OL046 in the same orientation, and torque fasteners to the chassis maker's recommended values. After fitment, check wheel alignment and suspension travel to confirm consistent handling.

Tuning role: swapping a left or right arm can remedy asymmetric steering or uneven tyre wear, and fitting a matched pair keeps suspension geometry steady when changing camber, toe, or roll centre during setup sessions.

Compatible Models

  • Outlaw Rampage PRO 2.0
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will the OL046 fit without trimming or modifications?

Yes. The OL046 is produced to match the mounting points of the Outlaw Rampage PRO 2.0 lower arm so installation should not require chassis trimming.

Can I install just one side or is replacement in pairs recommended?

You can replace a single side to restore function, but fitting a matched pair is recommended to maintain symmetrical handling and predictable setup changes.

What basic tools will I need for the swap?

Standard hand tools such as hex drivers, pliers, and a torque driver are sufficient for removing the wheel and lower-arm fasteners and refitting the OL046.

Which checks should I perform after installing the arm?

Confirm wheel alignment, verify full suspension travel without binding, and check steering centring to ensure the arm is seated correctly and geometry is restored.

Copyright © 2008-2026 rcjaz.ca All rights reserved